Offer up the water butt to the top down pipe sliding it inside the centre hole of the butt until it will go no further. With the butt against the wall, lower it onto the bottom pipe section. Now with butt seated level and evenly on the brackets, mark the position dead centre of the…
Read more
Taking the metal wall bracket E slide down the pipe via the cut section to align the protruding arms with height line A check that the bracket is dead centre of the pipe and that it is level (Use a spirit level). Mark the holes and drill two 10mm holes and using the two short plugs and…
Read more
Ensure that any top clip is positioned at a minimum of 240mm (9 ½”) above the top of reservoir D for ease of fitting.
Measure 1075mm (42 ½”) up from height line A and cut horizontally through the pipe. Now mark 140mm (5 ½”) above this cut and once again cut and remove this section C
Any bottom pipe clip must be 100mm (5″ ) below the waterbutt, if necessary reposition B
Decide the height and position at which you wish to fix the waterbutt, remember to allow enough room for your watering can under the tap. The suggested height is 400mm (16”) at this point mark a level line on the wall A
Recent Comments